Brightly Gleaming

A couple of quick cards this week made using Stampin’ Up! Brightly Gleaming set.  I wanted to create some clean and simple style cards predominantly using white and metallics.

First, I stamped two of the bauble images twice, embossed each pair in gold and silver and cut them out using the matching punches.  For my backgrounds, I wanted some texture so I embossed my card using the long-retired pine bough folder.

Next, I cut some strips of gold and silver glitter card to edge my card fronts and liners and heat embossed the sentiment from the set.

I heat embossed the smaller decoration onto the envelope and the liner and stuck the liner into the card base, adding the glitter strips to the edges.

I repeated the glitter edging on the card front pieces.

The last job was to add foam dimensionals to adhere the baubles and sentiments.

The resulting cards were simple but elegant that I’d be happy to have on my mantlepiece.

 

 

 

Images ©2019 Stampin’ Up!

Crackers for a Gift Box

On page 31 of the holiday catalogue, there’s a suggestion to make traditional cracker boxes using the Brightly Gleaming suite of products.  Whilst these aren’t the usual pulling-banging crackers, they can be at least filled with decent stuff rather than useless bits of plastic.  The crackers would also make ‘cracking’ gift boxes! 😊

The trick is to use the small ornament punch to make the holes which allow the ends to fold in.  In case you’ve not got the ornament punch, I did try it out using a circle punch. The sides are smaller on this one, 3.5cm each.  For this end, I used a ¾” punch……

….and this end used the 1” punch.  This end’s a bit gappy.

Anyway, onto the ornament punched cracker.  Since I don’t have any Brightly Gleaming DSP, I decorated some Highland Heather card with the ornament stamps.  Whilst the catalogue suggests sizes for the sides, that’s all the information it gives.  I cut out a square 7.5” and scored it as follows:

Next, I stuck a length of double-sided tape along the small tab, then punched the holes, lining up the small ornament punch along the score lines.

I had trouble getting the ends to fold in on my prototype so I scored along the top and bottom edges of the holes.  This made construction considerably easier.  If you wanted to be able to ‘pull’ the crackers, it’d probably require adding a perforated line down the centre of these score lines.

I lightly folded in the edges along the holes like this:

Then, I flattened it out again and folded along the other score lines.

The next job was to remove the backing tape and stick the edges together to form a tube.

Lengths of ribbon were tied around the holes to gather the ends.

Lastly, I made a tag using the scalloped tag topper punch and the Itty Bitty Christmas stamps.  These would look great on the Christmas table or for presenting a small gift.  Now, who wouldn’t want this awaiting them under the tree?

 

 

Images ©2019 Stampin’ Up!